Smart Ethernet Switch Series User’s Manual
Figure 6-6 Switch Configuration: VLAN Configuration
The following table describes the labels in this screen.
Table 6-4 Switch Configuration: VLAN Configuration
LABEL DESCRIPTION
VLAN Ability Select Disable to deactivate the VLAN function.
Select Port-based VLAN to set the switch to operate in port-based VLAN mode.
Select 802.1Q VLAN to set the switch to operate in tagged VLAN mode. Select
Admit Tag Only to set the switch to drop frames without VLAN information.
NOTE: When you change the VLAN mode, a warning screen displays. Click OK and
Apply to complete the mode change.
Unicast
Packet
Leaky
Select Enabled to allow unicast packets to travel to different VLANs.
Select Disabled to deactivate this feature. Unicast packets can only travel to the
specified VLAN.
ARP Packet
Leaky
Select Enabled to allow ARP packets to travel to different VLANs.
Select Disabled to deactivate this feature. ARP packets can only travel to the
specified VLAN.
Multicast
Packet
Leaky
Select Enabled to allow multicast packets to travel to different VLANs.
Select Disabled to deactivate this feature. Multicast packets can only travel to the
specified VLAN.
Output Port
Filtering
Use this table to configure whether the switch is to add VLAN information to outgoing
packets.
Port This field displays the port number.
Tagging
To Next Page
Loading...
