Lists of events
98-145510-E Appendix E: System messages E-8
0A039-0 WARNING GNSS device warning Local GNSS device warning.
0A03A-0 WARNING GNSS device error Local GNSS device error.
0A03B-0 ERROR Azi DDM shutdown The azimuth motor control has detected one of the
following situations: Extreme temperature, voltage,
current or velocity. The motor was then shut down. This
is usually a temporary situation and is probably fixed by
a restart of the system.
0A03C-0 ERROR Xel DDM shutdown As Azi DDM shutdown but detected by the cross-
elevation motor control.
0A03D-0 ERROR Ele DDM shutdown As Azi DDM shutdown but detected by the elevation
motor control.
0A03E-0 ERROR PMM shutdown As Azi DDM shutdown but detected by the polarisation
motor control.
0A03F-0 WARNING AMB timing This indicates a busy situation. It may occur during
installation procedures. No user interaction is required
unless it occurs repeatedly.
0A040-0 WARNING VIM cable attn The output power cannot be controlled correctly. Check
the Tx chain.
0A041-0 WARNING BUC voltage low The voltage for the BUC is too low, probably caused by a
malfunctioning VIM or BUC.
0A042-0 WARNING BUC voltage high The voltage for the BUC is too high probably caused by a
malfunctioning VIM.
0A043-0 WARNING LNB voltage low The voltage for the LNB is too low probably caused by a
malfunctioning VIM/TIM or LNB.
0A044-0 WARNING LNB voltage high The voltage for the LNB is too high probably caused by a
malfunctioning VIM/TIM.
0A045-0 WARNING PMM fan The fan is not working or the tacho input from the fan is
not connected. Check fan cable and fan.
0A046-0 WARNING Antenna temperature The temperature of the antenna is too high. Check if the
fan is working.
0A047-0 ERROR VIM PLL lock The PLL of the VIM/TIM is out of lock. Check the 10 MHz
reference signal.
0A048-0 WARNING VIM tuner lock The PLL of the second receiver (DVB) is out of lock.
Check the 10 MHz reference signal.
Event ID Severity Description Explanation
Table E-2: Event messages for antenna (Continued)
To Next Page
Loading...
