Code Blue IP2501-s - Page 35

Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-137-Hpage 35 of 67
IP1500 and IP2500 Series
Administrator Guide
HardwareSettings
Thespeakerphonehardwaresettingsareconguredby:
1. Selecting Hardware Settings under Code Blue(seefarleft-handcolumn).
2. SelecttheappropriateButton Count, Keypad Available settings under the Interface
section.
3. CheckingAuxOutput1willenabletheauxoutputrelay.Bydefault,theportissettoenable
 (ToggleState)whenusedinanActionScript.
When Momentary togglechoicehasbeenselected,thecalledpartynowhastheability
 toactivatetheauxoutputremotelyforthetimeperiodchosenviaDTMFtonesfromtheir
 phoneskeypad.
Note: Momentary toggleisintendedforremotecontrolusebythecalledparty.It’s
 importanttounderstandthatscripteduseoftheauxoutputnotbeusedonanyauxoutput
 portthathasbeenselectedtoactinthemomentary(remotecontrolaspect)togglefunction.
Also it is not recommended to use the General Settings > Incoming Calls > Aux Output 1
Enable on Incoming Callcheckbox.
4. Withselectionsmade,clickSave Changes.