Code Blue IP2501-s - Page 41

Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-137-Hpage 41 of 67
IP1500 and IP2500 Series
Administrator Guide
ACTION SCRIPT PARAMETERS (continued)
Place Call(continued)
When Answered: The default setting is
Normal Two-Way Conversation, the
optionistoPlay Custom Messages. A
messagecanbesettoplayLocally(at
thespeakerphone)and/orRemotely(to
the Called Party).
Choosingthisoptionwilladdanother
optiontothePlacecallsequence,And
Then.
The And Then choice allows the call
to continue through to normal two-way
conversationmodeorHang Up and
resetthespeakerphone.
Note:Inthisfeature,itisprohibitedtousethesameexactmessageinbothlocalandremotelyse-
lection.
In Call Commands: The default is Enabled.
All Remote Control DTMF tone commands
areavailableforusebythecalledparty.The
alternatechoiceisDisabled,effectivelylocking
out all DTMF tone commands from the Called Parties control.
Control AUX Output
• AuxOutputscanbeactivatedanddeactivatedthroughoutaScript.
• AuxOutputscanalsobesettoactivateonincomingansweredcalls.
• Itisstronglyadvisedthatwhenthisfeatureisusednoothercongurationsareenabledforan
AuxOutputwithMomentaryToggleselectedinHardware Settings.