The default mode is two-way audio upon the call being answered.
Default is to have the in-call commands available during the phone call. These can be
disabled for this action. In-call commands are also available on an inbound call into
LS1000. See section on in-call commands for the full list.
NOTE: It is advisable to keep your recordings short to establish connection to a two-
way call as quickly as possible.
Additional options include playing a custom recording locally out of the LS1000 speaker
and/or playing a custom recording remotely to the receiving party that identifies where
this call is coming from.
Note: This is a useful feature if the receiving party is not going to get a unique caller ID
name/number for this location.
You can select the audio of ring-back or use a custom recording that is uploaded into the
phone in the Recordings page. A common recording script would be something like,
“Security has been contacted; please stand by.”
This message will repeat just like ring-back would until the call is answered. This message
will stop when the call is answered.
Once the recording has played, two-way audio will commence.
NOTE: If playing a remote message but not a local message, then the person at the LS1000 will
hear dead air until the remote message is done playing. It is advisable to play the same message
to both parties in this case.
“While Dialing”
“When Answered”
“In-Call Commands”
LS1000 VoIP Speakerphone
Administrator Guide
page 30 of 54 GU-164-B
Code Blue
• 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com
To Next Page
Loading...
