Each iteration of the rolled over call uses the “Dialing/Answer Timeout.”
NOTE: If voicemail answers, then that is considered an answered call.
Repeat for the number of times you want the call to rollover before answering.
Select the Account that was created earlier that the calls will be routed through.
Enter in the “To” field the number you would like LS1000 to dial. For peer-to-peer,
enter the IP Address:Port the call is intended to go to.
“Maximum Call Duration” is 600 seconds or 10 minutes by default. This is used as a timer
in case the receiving party never hangs up the call. This timer is editable.
If that number does not answer, you can “Add Call” and select another account and phone
number to dial. This is useful if you have the phone registering to multiple SIP servers/SIP
PBXs. For example, you can have it call 911 from Account 1 and call 911 from Account 2 if
Account 1 is down. The phone will roll over to Account 2 and call out that account.
Place Call Action
LS1000 VoIP Speakerphone
Administrator Guide
page 29 of 54 GU-164-B
Code Blue
• 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com
To Next Page
Loading...
