LS1000 VoIP Speakerphone
Administrator Guide
page 46 of 54 GU-164-B
Code Blue
• 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com
14 Troubleshooting
The LS1000 is a network device. The following are tips for troubleshooting:
Power - Ensure the power to your device is working and rated for 802.11af/at PoE specifications
if using PoE. LS1000 should only have one source of power other than a backup battery. If not
using PoE, then main power needs to fall into 12 Volts DC.
Ping Test - This determines connectivity and the packet loss and latency time to and from your
destination and the quality of your network connection to LS1000. If you receive no response
and power is confirmed, contact your network administrator. You can also ping from within the
phone towards your IP PBX to test that it can reach its IP PBX/SIP Gateway.
Network – If you are putting LS1000 on a network that restricts ports, then the following ports
must be open for LS1000 to communicate to its appropriate IP PBX/SIP Gateway:
1. IAX2/UDP outgoing to port 4569 on IP PBX/SIP Gateway (only needed if using IAX2 instead of
SIP on the accounts page).
2. SIP/UDP outgoing to port 5060 IP PBX/SIP Gateway.
3. RTP/UDP incoming from IP PBX/SIP Gateway to UDP ports 23456-23556 (configurable).
DHCP - L1000 is set up for DHCP by default. If you cannot determine the IP address of your
LS1000, contact your network administrator.
Account - Ensure your SIP account is set up correctly. Account username and password must
match the account credentials on your VoIP system. This is the most common mistake with
setting up SIP accounts.
Codec - Ensure the codec settings on your VoIP system match the LS1000 codec settings.
Firewall - Firewalls commonly block or partially block VoIP calls. Check with your network
administrator if you cannot communicate with your LS1000 from behind a firewall.
Note: If you do not have a DHCP server running, use a standard home/wireless router and plug
your speakerphone and laptop into the same router. Once you know the IP Address, you can
browse to it via a web browser.
To Next Page
Loading...
