LS1000 VoIP Speakerphone
Administrator Guide
page 43 of 54 GU-164-B
Code Blue
• 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com
1. Navigate to System > Security > Phone Security Profile.
2. Do a Find on “Third-party” to locate the Third-party SIP Device Basic - Standard SIP Non-
Secure Profile. Click the Copy icon.
3. Check Enable Digest Authentication.
4. Change the Name and Description to Code Blue LS1000 Profile.
5. Click Save.
All UCM-side configuration is done within the Cisco Unified CM Administration web
interface.
Refer to Section 10 to complete the setup of the LS1000, including Numbers, General Settings,
Hardware Settings and Action Scripts. When finished, it should now register to CUCM and be
able to place calls in the assigned calling search space as well as receive calls at the directory
number it is configured with.
The Directory Number, User ID, and Last Name fields must all be the same.
Create and record a secure SIP password and fill in the Digest Credentials and Confirm
Digest Credentials fields with this password. You will be entering this password later into
the LS1000.
For each LS1000 device, configure a new end user for SIP authentication.
1. Navigate to User Management > End User.
2. Click Add New.
3. For the User ID, enter the Directory Number of the LS1000 phone.
4. Fill in the Last Name field with the Directory Number.
5. Click Save.
Note: If you are setting up the LS1000 with secondary account support, make sure that you
create each failover number twice.
UCM CONFIGURATION
Configure End Users
Create Phone Security Profile
Other Settings
To Next Page
Loading...
