C001537_15_CR2_User_Manual 57
Save Settings
6.4 - Reader Text Commands
Enabling Reader Text Commands allows the CR2 to accept text commands via RS-232 or RF commmunication. Scan
the following codes to enable/disable reader text commands:
Reader Text Commands On Reader Text Commands Off - Default
Note: Text commands can only be sent to the reader when it is active. Refer to Reader-Host Interface Control Document
for more information.
6.3 - Erase Prefi x and Suffi x Settings
Scan the following codes to erase all prefi x and suffi x data.
Erase Prefi x & Suffi x Data
To Next Page
Loading...
