Cognex CC24 - I;O Terminal Block Cable Specifications

I/O Terminal Block Cable Specifications
The I/O Terminal Block cable connects the Communication card directly to the Terminal Block accessory via the DB37
connector. When the Terminal Block accessory is used, all inputs, outputs and encoder lines used by the
Communication card are connected using the I/O Terminal Block cable.
Note: Cables are sold separately.
P1 Pin Number Signal Name P2 Pin Number
1 ENCODER A+ 25
2 ENCODER A- 12
3 ENCODER GROUND 13
4 OUTPUT COMMON 4 35
5 OUTPUT 15 33
6 OUTPUT 14 32
7 OUTPUT 13 31
8 OUTPUT 12 30
9 OUTPUT 11 29
10 OUTPUT 10 28
11 OUTPUT 9 27
12 OUTPUT 8 26
13 OUTPUT COMMON 3 34
14 INPUT COMMON 2 10
15 INPUT 7 8
16 INPUT 6 7
17 INPUT 5 6
18 INPUT 4 5
19 ENCODER B+ 24
20 ENCODER B- 11
21 NOT USED 36
22 OUTPUT COMMON 2 23
23 OUTPUT 7 21
24 OUTPUT 6 20
25 OUTPUT 5 19
26 OUTPUT 4 18
27 OUTPUT 3 17
28 OUTPUT 2 16
29 OUTPUT 1 15
22
Specifications