Precautions
To reduce the risk of injury or equipment damage, observe the following precautions when you install the Cognex product:
l
This product is intended for industrial use in automated manufacturing or similar applications.
l
The safety of any system incorporating this product is the responsibility of the assembler of the system.
l
This product does not contain user-serviceable parts. Do not make electrical or mechanical modifications to product
components. Unauthorized modifications can void your warranty.
l
Route cables and wires away from high-current wiring or high-voltage power sources to reduce the risk of damage or
malfunction from the following causes: over-voltage, line noise, electrostatic discharge (ESD), power surges, or other
irregularities in the power supply.
l
Changes or modifications not expressly approved by the party responsible for regulatory compliance could void the
user’s authority to operate the equipment.
l
Ensure that the cable bend radius begins at least six inches from the connector. Cable shielding can be degraded or
cables can be damaged or wear out faster if a service loop or bend radius is tighter than 10X the cable diameter.
l
This device should be used in accordance with the instructions in this manual.
l
All specifications are for reference purposes only and can change without notice.
6
Precautions
To Next Page
Loading...
