2
1
6. Disconnect the machine connector (1) of the battery connector (2).
7. Connect the battery charger connector to the battery connector (2).
8. Wait for the green LED of the battery charger to light.
9. Disconnect the battery charger connector from the battery connector (2).
10. Connect the machine connector (1) to the battery connector (2)
ATTENTION: If one of the three LEDs flashes refer to the
battery charger manual supplied with the machine
ATTENTION: the machine is equipped with an automatic
system that disconnects the power supply from the electrical
system while the batteries are being recharged
ATTENTION: in order not to cause permanent damage to the
batteries it is essential to avoid their complete discharge:
arrange the recharge within a few minutes of the switching on of
the flashing "discharged batteries" signal
ATTENTION: never leave the batteries completely discharged,
even if the machine is not being used
ATTENTION: for the daily recharging of the batteries, you must
fully respect the indications provided by the manufacturer or
retailer. All installation and maintenance operations must be
carried out by expert personnel, trained at the COMAC
assistance centre
ATTENTION: danger of exhalation of gas and leakage of
corrosive liquids
ATTENTION: danger of fire: do not go near with free flames
9. BATTERY INDICATOR
On the instrument panel of the machine there is a monitor indicating (amongst
other things) the battery charge status.
The battery indicator is digital, with 4 fixed positions and one flashing one to
indicate the approximate charge level.
4 = maximum charge, 3 = 3/4 charge, 2 = 2/4 charge, 1 = 1/4 charge,
STOP = batteries run down (flashing)
ATTENTION: a few seconds after the last indicator on the
monitor has flashed, the brush motor will automatically switch
off. With the remaining charge it is possible to complete the
drying process before recharging
To Next Page
Loading...
