25. AT THE END OF THE WORK
At the end of the work, and before carrying out any type of maintenance:
1. Raise the base by means of the momentary bipolar two-way switch on the
command panel.
2. Finish drying the floor, then raise the squeegee using the bipolar two-way
switch on the command panel.
3. Switch off the suction motor by means of the bipolar switch on the command panel.
4. Take the machine in an area designated for the disposal of liquids.
5. Turn the key of the master switch to the "OFF" position, and remove the key.
6. Engage the parking brake, by means of the lever on the side of the machine.
7. Disconnect the pipe from its hook, unscrew the discharge plug and empty the
recovery tank.
To simplify the draining operation, you are advised to keep the tube bent with one
hand and, with the other, unscrew the knob and remove the plug.
Slowly straighten the tube and the liquid will start draining at the desired speed.
ATTENTION: This operation must be carried out using gloves to
protect against contact with dangerous solutions
8. disassemble the brushes and clean them with a jet of water (to disassemble
the brushes, see “DISASSEMBLING THE BRUSHES” below)
9. When you have finished working, park the machine in a closed place,
remembering to raise the base and squeegee.
10.
ATTENTION: do not leave the machine unattended without first
removing the start-up switch key and applying the parking brake.
In addition, do not park the machine in open or damp places, or
on sloping floors
To Next Page
Loading...
