DAILY MAINTENANCE
26. CLEANING THE RECOVERY TANK
1. Take the machine in an area designated for the disposal of liquids.
2. Engage the parking brake.
3. Turn the key of the master switch to the "OFF" position, and remove the key.
4. Check the recovery tank is empty (if necessary, empty it).
5. Remove the drainage tube from its seat.
6. Release the cap.
7. Release the hinge on the front part of the solution tank.
8. Rotate the recovery tank until the prop engages with its first rotation step.
9. Rinse the inside of the tank well with a jet of water.
10. Bring the recovery tank back to the starting position.
11. Close the recovery tank fixing hinges on the sides of the machine.
12. Tighten the recovery tank drainage tube cap.
13. Reposition the recovery tank drainage tube in its seat.
ATTENTION: These operations must be carried out using gloves
to protect against contact with dangerous solutions
27. CLEANING THE SUCTION FILTER
1. Take the machine in an area designated for the disposal of liquids.
2. Engage the parking brake.
3. Turn the key of the master switch to the "OFF" position, and remove the key.
4. Release the suction cap fixing hinges on the sides of the recovery tank.
5. Rotate the recovery tank until the prop engages with its first rotation step.
6. Remove the suction filter protection by rotating it clockwise.
7. Remove the suction filter from its seat
8. Use a jet of water to clean the walls and base of the filter.
9. Reassemble all the elements.
ATTENTION: These operations must be carried out using gloves
to protect against contact with dangerous solutions
2
3
To Next Page
Loading...
