3. Remove the inlet cap located on the left side of the machine.
4. Check the filter cover (1) on the front left of the machine is correctly closed.
5. Fill it with clean water at a temperature not exceeding 50°C.
The solution tank has a maximum capacity of about 75 litres for the Tripla 60
2009, and 95 litres for the Tripla 65-75 2009. Add the liquid detergent to the tank
in the concentration and manner indicated on the detergent manufacturer's
label. The formation of excess foam could damage the suction motor, so use
only the minimum amount of detergent necessary.
ATTENTION: always use detergents whose manufacturer's
label indicates their suitability for scrubbing machines. Do not
use acid or alkaline products or solvents without this indication.
In addition, you are advised to always use low foam detergents.
Do not use pure acids
ATTENTION: Protective gloves should always be worn before
handling detergents or acidic or alkaline solutions to avoid
serious injury to hands.
17. SOLUTION TANK WITH AUTOMATIC CDS DISTRIBUTION SYSTEM
Proceed as follows to fill the solution tank:
1. Turn the key of the master switch anticlockwise to the “OFF” position.
2. Engage the parking brake.
6. Remove the inlet cap located on the left side of the machine.
7. Check the filter cover (1) on the front left of the machine is correctly closed.
8. Fill it with clean water at a temperature not exceeding 50°C.
To Next Page
Loading...
