CHOOSING AND USING THE BRUSHES
POLYPROPYLENE BRUSH (PPL)
Used on all types of floors. Good resistance to wear and tear, and hot water (no greater than 60°C). T he Polypropylene brush is
non-hygroscopic and therefore retains its characteristics even when working in wet conditions.
ABRASIVE BRUSH
The bristles of this type of brush are charged with highly aggressive abrasives. It is used to clean very dirty floors. To avoid
floor damage, work only with the pressure strictly necessary.
THICKNESS OF THE BRISTLES
Thicker bristles are more rigid and are therefore used on smooth floors or floors with small joints.
On uneven floors or those with deep joints, it is advisable to use softer bristles which can enter the gaps more easily.
Remember that when the bristles are worn and therefore too short, they will become rigid and are no longer able to penetrate
and clean deep down. In this case, like with overlarge bristles, the brush tends to jump.
PAD HOLDER
The pad holder is recommended for cleaning shiny surfaces.
There are two types of pad holder:
1. the traditional pad holder is fitted with a series of anchor points that allow the abrasive floor pad to be held and dragged
while working
2. the CENTRE LOCK type pad holder not only has anchor points, but also a snap-type central locking system in plastic that
allows the abrasive floor pad to be perfectly centred and held without any risk of it becoming detached. This type of
dragging device is recommended above all for machines with more than one brush, where the centring of the abrasive
discs is difficult
TABLE FOR CHOOSING THE BRUSHES
Machine No. of brushes Code Type of bristles ØBristles Ø Brush Length Notes
405627 NYLON 0.9 WHITE
405629 0.9 BLACK
405630
PPL
0.6 WHITE
Tripla 60
2009
1
405628
ABRASIVE
610
422189 0.3
422971 0.6
422972
PPL
0.9
Tripla 65
2009
2
422981 ABRASIVE
340
427715 0.3 BLUE
427716 0.6 WHITE
427717
PPL
0.9 BLACK
Tripla 75
2009
2
427719 ABRASIVE
390
PAD HOLDER SELECTION TABLE
Machine No. Pad
To Next Page
Loading...
