30.CLEANING THE CLEAN WATER FILTER
1. Take the machine in an area designated for the disposal of liquids.
2. Engage the parking brake.
3. Turn the key of the master switch to the "OFF" position, and remove the key.
4. Make sure that the solution tank is empty
5. Loosen the solution tank filter cap
6. Unthread the filter cartridge and clean it with a jet of running water
7. Reassemble all the elements.
ATTENTION: These operations must be carried out using gloves
to protect against contact with dangerous solutions
31. CLEANING THE SOLUTION TANK
1. Take the machine in an area designated for the disposal of liquids.
2. Engage the parking brake.
3. Turn the key of the master switch to the "OFF" position, and remove the key.
4. Loosen the solution tank filter cap
5. Remove the filter cartridge
6. Loosen the inlet cap on the left side of the machine
7. Rinse the inside of the tank with a jet of running water
8. Reassemble all the elements.
32. DISASSEMBLING THE BRUSH (TRIPLA 60 2009)
1. Engage the parking brake.
2. Turn the key of the master switch to the "OFF" position, and remove the key.
To Next Page
Loading...
