Comau Robotics C5G - Page 52

52
HS-RC-C5E-E1xx_01.fm
00/0309
d. The area to be cleaned is the
fan (A) and dissipator (B) one.
Be careful, as the
recovery resistance
may be very hot.
e. Remove the dirt using the
brush, in particular on the fan
(A) blade inside area.
f. Remove the dirt from the panel
grids (C).
g. Mount the Rear panel (see par.
5.3.3 on page 38) back.
Follow-up procedure
– Not required
Operating procedure