General Safety Precautions
9
ge-0-0-0_01.FM
00/0710
1. GENERAL SAFETY PRECAUTIONS
This specification deals with the following topics:
– Responsibilities
– Safety Precautions.
1.1 Responsibilities
– The system integrator is responsible for ensuring that the Robot System (Robot
and Control System) are installed and handled in accordance with the Safety
Standards in force in the country where the installation takes place. The application
and use of the protection and safety devices necessary, the issuing of declarations
of conformity and any CE markings of the system are the responsibility of the
Integrator.
– COMAU Robotics & Service shall in no way be held liable for any accidents caused
by incorrect or improper use of the
Robot System (Robot and Control System), by
tampering with circuits, components or software, or the use of spare parts that are
not included in the spare parts list.
– The application of these Safety Precautions is the responsibility of the persons
assigned to direct / supervise the activities indicated in the
Applicability sectionally
are to make sure that the Authorised Personnel is aware of and scrupulously follow
the precautions contained in this document as well as the Safety Standards in
addition to the Safety Standards in force in the country in which it is installed.
– The non-observance of the Safety Standards could cause injuries to the operators
and damage the
Robot System (Robot and Control System).
It deals with a general specification that apply to the whole Robot System. Due to
ist significance, this document is referred to unreservedly in any system
instruction manual.
The installation shall be made by qualified installation Personnel and should
conform to all national and local codes.
To Next Page
Loading...
Need help?
General