12
MACHINE PREPARATION
5. Keep the motor running at minimum speed, with the accelerator lever in position (1), for
about 5 minutes to warm up the motor before beginning to work. Check that with the motor
on, the green indicator light (3) and the red indicator light (9) are lit up.
6. Quickly raise the accelerator lever so that all the green voltage indicator lights (10) come
on.
7. The green indicator light (12) near the steering wheel will come on when the motor has
reached its optimum speed for correct machine operation.
ATTENTION: see the Yanmar motor instruction manual.
5. VOLTAGE LEVEL INDICATOR
This indicator operates by means of LEDs. The LEDs that appear on the display show the
approximate system voltage level.
4 = 34V, 3 = 33V, 2 = 32V, 1 = 31V, 0 = insufficient voltage (the machine system is disabled)
WARNING: a few minutes after switch-on, you can accelerate until all the LEDs
go off.
6. FUEL TANK
The fuel tank (13) is located behind the operator's seat.
Loosen the cap and pour in the most suitable diesel fuel for the motor.
Retighten the cap very well.
WARNING: use diesel fuel with a cetane number higher than 45.
13
To Next Page
Loading...