21
WORK
TRACTION
These machines are equipped with electronically commanded traction, with three
speeds forwards and one backwards. To move the machine, move the lever (1)
forwards (forward movement) or backwards (reverse movement). Press the drive
pedal and the machine will start to move. The movement speed can be adjusted
by rotating the selector (2).
ATTENTION: do not press the pedal before selecting forward or reverse
movement
NOTES: during reverse movements, if the two-way manual/automatic switches (1
and 2) of the squeegee and tunnel are on manual, remember to raise the
squeegee and tunnel via the lever (3). During transfer movements, put the two-
way switches (1 and 2) on manual.
AUTOMATIC - MANUAL SQUEEGEE
Automatic: if the two-way switch is placed on automatic, the squeegee lowers and
the suction motors start up when the machine moves forwards. In the same way,
the squeegee rises and the suction motors stop when the machine moves
backwards.
Manual: if the two-way switch is placed on manual, the squeegee has to be lifted
and lowered manually by means of the lever (2). Suction motor operation is
commanded in any case by the movement of the squeegee.
CYLINDRICAL BRUSH BASE (TUNNEL) - AUTOMATIC / MANUAL
Automatic: If the two-way switch is placed on automatic, the tunnel lowers and the
cylindrical brush motor starts up when the machine moves forwards. In the same
way, the tunnel rises and the suction motor stops when the machine moves
backwards.
Manual: If the two-way switch is placed on manual, the tunnel has to be lifted and
lowered manually by means of the lever (2). Motor operation is commanded in
any case by the movement of the tunnel.
To Next Page
Loading...