26
DAILY MAINTENANCE
REPLACING THE SQUEEGEE RUBBER
If the squeegee rubber is worn and does not dry well, it is possible to change the
drying edge, proceeding as follows:
1. push and rotate the fixing plates
2. remove the rubber-pressing blade and the rubber itself
3. turn the rubber upside-down and, if necessary, replace it
4. adjust the squeegee height as indicated in “ADJUSTING THE SQUEEGEE
SUPPORT HEIGHT” in the chapter “MACHINE PREPARATION”
5. reassemble everything, carrying out the above-mentioned operations in the
reverse order
DISASSEMBLING THE BRUSHES
1. Connect the battery connector if it is not already connected
2. Switch on the motor (see "Motor start-up") by turning the key to the ON
position
3. Use the lever to lower the base until it lightly touches the floor (do not lower
it completely)
4. Turn the key to the OFF position and remove it from the panel (carrying out
the brush disassembly operation with the power supply connected may
cause injuries to the hands)
5. loosen the knobs (1) shown in the figure
6. Remove the bases by pulling on them
7. Raise the bases with the aid of a tool that is suitable for both the weight
(60kg) and the type of hooks (see the special labels)
8. With the base up, rotate the brush until it comes out of the brush-holder
plate seat, as shown in the figure. The photo shows the direction of rotation
for releasing the right brush. Rotate in the opposite direction for the left
brush.
To Next Page
Loading...