17
GENERAL SAFETY REGULATIONS
The regulations illustrated below must be carefully followed in order to avoid harm to the operator and damage to the machine.
Read the labels on the machine carefully. Do not cover them for any reason and replace them immediately if they become damaged
The machine must be used exclusively by authorised, trained personnel
During the working of the machine, pay attention to other people and especially to children
Do not mix different types of detergent as this may produce harmful gases
Do not place any liquid containers on the machine
The storage temperature must be between -25°C and +55°C
The optimum working temperature must be between 0°C and 40°C
The degree of humidity must be between 30 and 95%
Do not use the machine in an explosive atmosphere
Do not use the machine as a means of transport
Do not use the machine in closed environments
Do not use acid solutions that could damage the machine and/or harm people
Avoid working with the brushes when the machine is standing still, so as not to damage the floor
Do not vacuum inflammable liquids
In the event of a fire, use a powder extinguisher. Do not use water
Do not knock against shelving or scaffolding, where there is a danger of falling objects
Adapt the speed to the adhesion conditions
WARNING! Do not exceed the gradient limit as this could cause conditions of instability
When the machine is in parking mode, remove the key and insert the parking brake
The machine is designed to carry out the washing and drying operations simultaneously. Different operations should only be carried out
in areas where the passage of unauthorised persons is prohibited. Signal the presence of damp floors with suitable signs
If the machine does not work properly, check this is not caused by failure to carry out routine maintenance. Otherwise, request the
intervention of the COMAC technical service
If you need to replace any components, request the ORIGINAL spare parts from an Authorised dealer and/or Retailer.
Use only the original COMAC brushes indicated in the paragraph “CHOOSING AND USING THE BRUSHES"
In the event of danger, activate the emergency lever (connector placed on the left side of the operator) immediately
Do not remove any protection devices which require the use of tools in order to be removed
Do not wash the machine with direct water jets or with pressurised water, nor with corrosive substances
After every 200 hours of operation, have the machine checked by a COMAC assistance centre
The machine should not be abandoned, due to the presence of toxic-harmful materials (batteries, oil etc.) subject to regulations which
provide for their scrapping in the appropriate centres
To prevent the formation of scale in the solution tank filter, do not fill the tank with detergent solution many hours before using the
machine.
Before using the machine, check that all the hatches are positioned as shown in this Use and Maintenance Manual
To Next Page
Loading...