4
On consignment of the machine
When the machine is consigned to the customer, an immediate check must be performed to
ensure all the material mentioned in the shipping documents has been received, and also to
check the machine has not suffered damage during transportation. If this is the case, the
carrier must ascertain the extent of the damage at once, informing our customer service
office. It is only by prompt action of this type that the missing material can be obtained, and
compensation for damage successfully claimed.
Introduction
This is a sweeping/scrubbing machine which, via the abrasive mechanical action of the four
rotating brushes, the sweeping action of a cylindrical brush, and the chemical action of a
water/detergent solution, can clean any type of flooring. As it advances, it also collects the dirt
removed and the detergent solution not absorbed by the floor. The machine must be used
only for this purpose. Even the best machines will only work well if used correctly and kept in
good working order. We therefore suggest you read this instruction booklet carefully and read
it again whenever difficulties arise while using the machine. If necessary, remember that our
customer assistance service (organised in collaboration with our dealers) is always available
for advice or direct intervention.
TECHNICAL DESCRIPTION C130D
Working width mm 1300
Lateral movement of base mm 100
Squeegee width mm 1460
Work capacity sq.m/h 7800
Cylindrical brush ∅ mm 300x1100
Cylindrical brush rotations rpm 580
Cylindrical brush motor V 36
Cylindrical brush motor W 750
Counter-rotating brushes (4) ∅ mm 345
Brush rotations rpm 220
Pressure on the brushes kg 130÷180
Maximum specific pressure rev/s / 66
Brush motor V 36
Brush motor W 1125
Brush motor V 36
Brush motor W 2000
Traction wheel ∅ mm 350x130
Forward speed km/h 0÷6
Maximum gradient with full load 10%
Suction motor V 36
Suction motor W 1170
Suction vacuum mbar 225
Rear elastic wheels ∅ mm 370x105
Solution tank l 360
Recovery tank l 380
Steering diameter mm 3250
Machine length mm 2250
Machine height mm 1880
Machine width (without squeegee) mm 1340
Batteries (start-up) V/Ah 12/45
Type of motor DIESEL
Machine weight (when empty) kg 1100
Noise level (in compliance with IEC 704/1) dB (A) 82
Body vibration level m/s² 0.85
Hand vibration level m/s² 1.15
To Next Page
Loading...