23
AT THE END OF THE WORK
At the end of the work, and before carrying out any type of maintenance, perform
the following operations:
1. turn off the tap
2. Raise the brush base
3. switch off the brush motor switch
4. switch off the solenoid valve switch
5. Switch off the cylindrical brush motor switch
6. switch off the suction motor switch
7. position the squeegee switch on manual mode
8. raise the squeegee
9. Position the tunnel two-way switch on manual
10. Raise the tunnel
11. bring the machine to the place provided for draining the water
12. Lower the motor acceleration lever until the green indicator lights go off (the
red LED will automatically switch back on again)
13. Position the key of the main switch on OFF
14. Disconnect the pipe from its hook, unscrew the drainage cap, and empty the
recovery tank
ATTENTION: This operation must be carried out using gloves to protect
against contact with dangerous solutions
To Next Page
Loading...