24
AT THE END OF THE WORK
15. Remove the clip from the right-hand side bar, and rotate it outwards
16. Release the pin (1) of the hopper
17. Take out the hopper (2) and clean it thoroughly (see “CLEANING THE
HOPPER” below). This operation must be carried out using gloves to protect
against contact with dangerous solutions
18. Raise the squeegee and clean it with a jet of water. The squeegee must be
raised when the machine is not operating, to avoid deforming the rubber
blades.
19. Disassemble the brushes and clean them with a jet of water (to disassemble
the brushes, see “DISASSEMBLING THE BRUSHES” below).
To Next Page
Loading...