25
DAILY MAINTENANCE
CLEANING THE RECOVERY TANK
This operation must be carried out using gloves to protect against contact with
dangerous solutions
1. Empty the tank by means of the flexible tube, turning the knob a couple of
times to loosen it and then removing the cap
2. Open the side cap by loosening the knob and rotating the closure blade
3. Rinse the tank and clean the drainage cap
4. Check the correct position of the seal on the side cap
5. Reposition the side plug and the plug on the exhaust pipe
CLEANING THE RECOVERY TANK FILTER
1. Lift the lid of the recovery tank
2. Rinse the tank with a water jet
3. Take out the filter of the float switch installed in the tank
4. Wash it thoroughly then reposition it
CLEANING THE SQUEEGEE
Clean the squeegee with a jet of water. Check the state of wear and tear of the
rubbers, turning or replacing them if necessary. The careful cleaning of the entire
aspiration unit ensures a longer working life for the suction
motors.
To Next Page
Loading...