DOCUMENTATION
AND
DISKS
Brief descriptions the documentation and disks supplied with the
Commodore 128 are given here.
Introductory Guide
The Introductory Guide (this manual)
is
a basic guide describing the
equipment, how to set it
up
and connect
it
It
also describes the three
modes available
on
the Commodore 128 Personal Computer and gives
instructions
on
how to access and use them.
System Guide
The System Guide provides you with all the information you need
to
create
and run your own programs
in
all three of the Commodore 128's modes.
It
describes the Commodore 128
in
detail and
is
designed
to
help you make
full use of its advanced capabilities.
The
CP/M
Systems Disk
This disk contains the
CP
I M operating system software together with
an
extensive
HELP
utility program. This software
is
loaded into the computer's
memory when
CP
I M software
is
to
be
run or any other operations are to
be
carried out under that operating system.
SETTING
UP
THE
EQUIPMENT
The minimum system for using the Commodore 128 Personal Computer
is
the C128 itself, a suitable monitor or
TV
set and a
1541
or
1571
disk drive.
If you intend to use C64 Mode with cassette based software only, the disk
drive can
be
replaced
by
a cassette
unit
Following the instructions
on
the label on the C128 mains power lead,
connect a plug
to
that lead if one
is
not already fitted. The other end of that
lead
is
plugged into the Power Socket on the side of the C128.
8
To Next Page
Loading...
