Commodore 128 - Page 39

LOADING programname
is displayed. When this is
complete, the READY. message
is displayed with the cursor
below
it. The program can now
be run or amended as you
require. To
run the program type:
RUN
and press RETURN.
33
In C128 Mode the SAVE and
LOAD commands can
be
replaced by the DSAVE and
DLOAD commands.
In this case,
the ,8
is omitted from the end of
the instruction. C128 Mode has
"s horthand" methods for entering
these two commands on the
screen. Pressing
F5 causes
DSAVE" to put displayed
on the
screen, and pressing
F2 causes
DLOAD" to be displayed
on the
screen. You then enter the name
of your program and press
RETURN. Your program is then
SAVEd to disk, or LOADed from
disk, as appropriate.