5-8 Working with Removable Drives and Device Bays
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Writer: Beth Zanca Saved by: Compaq Customer Saved date: 04/26/00 4:26 PM
Part Number: 170045-002 File name: Ch05
Using the CD or DVD Drive
Inserting a CD or DVD
1. Turn on the computer.
2. Press the eject button on the bezel of the CD or DVD drive to
release the loading tray.
3. Slowly pull out the loading tray until it is fully extended.
4. Remove the CD from its protective case and place it in the
loading tray, label side up. Handle the CD or DVD by the
edges, not by the flat surfaces.
5. Push lightly on the bezel of the loading tray to close it.
The light on the CD or DVD drive turns on while the computer
reads the CD’s or DVD’s table of contents. The light turns off
when the CD or DVD drive is ready to receive commands.
Removing a CD or DVD
1. Turn on the computer.
2. Press the eject button on the front panel to open the loading
tray.
3. Slowly pull out the loading tray until it is fully extended.
4. Remove the CD or DVD from the tray. Handle the CD or
DVD by the edges, not by the flat surfaces.
5. Place the CD or DVD in its protective case.
6. Gently push the front panel of the loading tray to close it.
To Next Page
Loading...
Need help?
General