Compaq Deskpro 2000 Service & Reference Guide

Compaq Service Reference Guide J-11
Test Error Codes
Continued
Error
Code Description Recommended Action
XXXX-36 Invalid SCSI bus phase. Replace the indicated device.
XXXX-39 Error status from drive. Replace the indicated device.
XXXX-40 Target timed out. Replace the indicated device.
XXXX-41 SCSI bus stayed busy. Replace the indicated device.
XXXX-42 ACK/REQ lines bad. Replace the indicated device.
XXXX-43 ACK did not deassert. Replace the indicated device.
XXXX-44 Parity error. Replace the indicated device.
XXXX-50 Data pins bad. Replace the indicated device.
XXXX-51 Data line 7 bad. Replace the indicated device.
XXXX-52 MSG, C/D, and/or I/O lines bad. Replace the indicated device.
XXXX-53 BSY never went busy. Replace the indicated device.
XXXX-54 BSY stayed busy. Replace the indicated device.
XXXX-60 Controller CONFIG-1 register bad. Replace the indicated device.
XXXX-61 Controller CONFIG-2 register bad. Replace the indicated device.
XXXX-65 Media not unloaded. Replace the indicated device.
XXXX-90 Fan failure. 1. Ensure fan(s) connected.
2. Replace nonfunctional fan(s).
XXXX-91 Over temperature. 1. Ensure proper air flow.
2. Perform required maintenance and cleaning.
XXXX-99 Autoloader reported tapes not
loaded properly.
1. Install tape(s) in autoloader tape drive according to test
instructions.
2. Change autoloader magazine.

Compaq Deskpro 2000 Specifications

General

Brand	Compaq
Model	Deskpro 2000
Category	Desktop
Language	English