2-8 Setup Utilities and Diagnostic Features
Computer Setup Menu
Continued
Heading Option Description
Power Energy Saver Allows you to set energy saver mode to Advanced, Disabled, or
Minimal.
Note:
In the minimal energy saver mode setting, the hard drive
and system do not go into energy saver mode, but the setting
allows you to press the power button to suspend the system.
This option is not available under ACPI-enabled operating
systems.
Timeouts Allows you to enable/disable timeouts or manually select timeout
values.
Note:
This selection will appear only when energy saver mode
is set to advanced. This option is not available under ACPI-
enabled operating systems.
Energy Saver Options Allows you to set power button configuration (on/off or wakeup.)
Allows user to enable/disable power LED blink in suspend
mode.
Note:
This selection will appear only if the energy saver mode is
enabled. This option is not available under ACPI-enabled
operating systems.
Advanced* Power-On Options Allows you to set POST mode (QuickBoot or FullBoot every N
days where n = 1 to 30) and enables/disables POST messages.
Enables/disables POST messages, Safe Post, F10 prompt, F12
prompt, option ROM prompt, and UUID.
Allows you to select the wakeup boot source (local hard drive or
remote server).
Allows you to select computer state after a power loss (On or
Off)
Onboard Devices Allows you to set resources for onboard system devices (serial
port, parallel port, diskette controller, etc.).
PCI Devices Lists currently installed PCI devices and their IRQ settings.
Allows you to reconfigure IRQ settings for these devices or to
disable them entirely.
Bus Options Enables/disables PCI bus mastering, PCI VGA palette snooping,
PCI SERR# generation, 15 MB memory hole, and ECC on select
models
Allows you to set ISA back-to-back I/O (fast/legacy) delay and
bus priority (ISA/PCI).
*These options should be used by advanced users only.
Continued
To Next Page
Loading...
Need help?
General