Compaq Service Reference Guide 2-9
Computer Setup Menu
Continued
Heading Option Description
Advanced*
(continued)
Device Options Allows you to set printer mode (EEP+ECP, Output only, bi-
directional, and NumLock state at power-on.
Enable/disable PME wakeup events, processor cache,
processor number, ACPI thermal mode, and ACPI S3 support.
(When ACPI S3 is enabled you may also enable/disable ACPI
S# video repost and hard disk reset.)
Allows you to select AGP aperture size (4, 8, 16, 32, 64, 128, or
256 MB)
PCI VGA Configuration Allows users to specify which VGA controller will be the boot or
primary VGA controller.
Appears only if there are multiple PCI video adapters in the
system.
*These options should be used by advanced users only.
To Next Page
