B-2 Power Cord Set Requirements
Country-Specific Requirements
Additional requirements specific to a country are shown in parentheses and explained below.
Country Accrediting Agency Country Accrediting Agency
Australia (1) EANSW Italy (1) IMQ
Austria (1) OVE Japan (3) JIS
Belgium (1) CEBC Norway (1) NEMKO
Canada (2) CSA Sweden (1) SEMKO
Denmark (1) DEMKO Switzerland (1) SEV
Finland (1) SETI United Kingdom (1) BSI
France (1) UTE United States (2) UL
Germany (1) VDE
Notes:
(1) The flexible cord must be <HAR> Type HO5VV-F, 3-conductor, 1.0 mm
2
conductor size. Power
cord set fittings (appliance coupler and wall plug) must bear the certification mark of the agency
responsible for evaluation in the country where it will be used.
(2) The flexible cord must be Type SJT or equivalent, No. 18 AWG, 3-conductor. The wall plug must be
a two-pole grounding type with a NEMA 5-15P (15A, 125V) or NEMA 6-15P (15A 250V) configuration.
(3) The appliance coupler, flexible cord, and wall plug must bear a "T" mark and registration number in
accordance with the Japanese Dentori Law. The flexible cord must be Type VCT or VCTF, 3-conductor,
0.75 mm
2
conductor size. The wall plug must be a two-pole grounding type with a Japanese Industrial
Standard C8303 (15A, 125V) configuration.
To Next Page
Loading...
Need help?
General