Compaq Deskpro 2000 Service & Reference Guide

Compaq Service Reference Guide D-5
POST Error Messages
Continued
Screen Message Beeps* Probable Cause Recommended Action
610-External Storage
Device Failure
None External tape drive not
connected.
Reinstall tape drive or press F1 and
allow system to reconfigure without
the drive.
611-Primary Floppy Port
Address Assignment Conflict
2S Configuration error. 1. Run Computer Setup (F10
Setup).
2. Remove expansion cards.
3. Clear CMOS.
612-Secondary Floppy Port
Address Assignment Conflict
2S Configuration error. 1. Run Computer Setup (F10
Setup).
2. Remove expansion cards
3. Clear CMOS.
660-Display Cache is
Detected Unreliable
None Integrated video controller
display cache not working
properly and will be disabled.
Replace system board if minimal
video degrading is an issue.
912-Computer Cover Has
Been Removed Since Last
System Start Up
None No action required.
914-Hood Lock Coil is not
Connected
None Hood lock mechanism is
missing or not connected.
1. Reconnect or replace hood
locking mechanism.
2. Reseat or replace hood locking
mechanism cable.
916-Thermal Sensor from
Processor Heatsink is not
Connected.
None Processor Heatsink cable not
connected to system board.
Reseat or replace the Processor
Heatsink cable going to the system
board.
917-Expansion Riser not
Detected
None Riser board not seated or not
installed.
Install riser board if missing or
remove and reseat to ensure good
connection.
1151-Serial Port 1 Address
Conflict Detected
2S Both external and internal
serial ports are assigned to
COM1.
1. Remove any Comm port
expansion cards.
2. Clear CMOS.
3. Reconfigure card resources
and/or run Computer Setup (F10
Setup).Run Computer Setup or
Windows utilities.
* L = Long, S = Short
Continued

Compaq Deskpro 2000 Specifications

General

Brand	Compaq
Model	Deskpro 2000
Category	Desktop
Language	English