Compaq ProLiant 3000 Setup And Installation

5-18
Server Configuration and Utilities
Writer: Tom Erber Project: ProLiant 3000 Setup and Installation Guide Comments: 296908-002
File Name: F-CH05.DOC Last Saved On: 1/27/98 4:22 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Manual installation
If you choose not to let SmartStart configure the server, follow this procedure:
1. Insert the Compaq SmartStart and Support Software CD into the CD-
ROM drive.
2. Boot your system.
3. Select Non-SmartStart Setup.
4. Follow the instructions that display on the monitor.
IBM OS/2 Device Drivers from Compaq
Your server must have certain device drivers for some server options to operate
using IBM OS/2 Warp Server 4.0, IBM OS/2 Warp Server 4.0 SMP, OS/2
Warp, OS/2 Warp Connect 3.0, and OS/2 2.x. These drivers are located on the
Compaq SmartStart and Support Software CD you received with your server. If
you use SmartStart to install your operating system, these drivers are loaded
automatically. Otherwise, you can use SmartStart to create an OS/2 Support
Software Diskette (SSD) from Compaq to support a manual installation of
OS/2.
For more information on these drivers, run the README.COM file in the root
directory of the OS/2 SSD from Compaq.
Manual installation
If you choose not to let SmartStart configure the server, follow this procedure:
1. Insert the Compaq SmartStart and Support Software CD into the drive.
2. Boot your system.
3. Select Non-SmartStart Setup.
4. Follow the instructions that display on the monitor.

Compaq ProLiant 3000 Specifications

General

Brand	Compaq
Model	ProLiant 3000
Category	Server
Language	English