Introduction I 1-5
1
Introduction
How to Use the Lockout Device
CAUTION: Before performing maintenance or repairs on this product, you should
disconnect and lockout electrical power sources to prevent injury from unex-
pected energization or start-up. A lockable device may be provided to isolate this
product from potentially hazardous electricity.
WARNING: Before removing lockout devices and returning switches to the ON
position, make sure that all personnel are clear of the machine, tools have been
removed and all safety guards reinstalled.
Lockout is the preferred method of isolating machines or equipment from energy sources.
Your Conair product may be equipped with the lockout device pictured below. To use the
lockout device:
1 Stop or turn off the equipment.
2 Isolate the equipment from the electric power.
3 Turn the rotary disconnect switch to the OFF, or “O” position
4 Secure the device with an assigned lock or tag.
5 The equipment is now locked out.
If the machine has no included lockout device, perform the same procedure at the up-
stream device as part of premises electrical system. Incoming cooling water and com-
pressed air (if purge) are additional energy sources that need to be controlled.
To Next Page
Loading...
Need help?
General
