Troubleshooting I 6-3
6
Troubleshooting
A Few Words of Caution
WARNING: Improper installation, operation or
servicing may result in equipment damage or
personal injury.
This equipment should only be installed, adjusted, and serviced by qualified technical
personnel who are familiar with the construction, operation, and potential hazards of this
type of machine.
All wiring, disconnects, and fuses should be installed and adjusted by qualified electrical
technicians in accordance with electrical codes in your region. Always maintain a safe
ground. Do not operate the equipment at power levels other than what is specified on the
machine serial tag and data plate.
WARNING: Electrical hazard
Before performing maintenance or repairs on this product, disconnect and lock out electri-
cal power sources to prevent injury from unexpected energization or start-up. A lockable
device has been provided to isolate this product from potentially hazardous electricity.
WARNING: Compressed air hazard
If you use compressed air, you must wear eye protection and observe all OSHA and other
safety regulations pertaining to the use of compressed air. Bleed off pressure before ser-
vicing equipment.
WARNING: Hot surface and liquid hazards.
Before attempting maintenance of any kind on the Thermolator, you must stop the unit,
disconnect and lockout the main power supply, and allow the unit to cool to less than
100° F {38° C}.
To Next Page
Loading...
Need help?
General
