EasyManuals Logo

Control Techniques DIN1220075A User Manual

Control Techniques DIN1220075A
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
Dinverter
A
User Guide
Issue code: d2au9
35
4.5 Wiring recommendations
Caution
When the motor phase connections are made (U-to-U,
V-to-V, W-to-W) and a RUN FORWARD command is given to
the Drive, the motor runs in the reverse direction
(anticlockwise rotation as seen from the shaft-end of the
motor). To make the motor run in the opposite direction,
exchange two of the phase connections.
Observe the wiring recommendations given in this section. The details of
individual installations may vary, but details which are indicated in the
recommendations to be important for EMC must be adhered to closely.
When external signal connections are to be made to the Drive, also refer to
Signal connections for operation in Terminal mode later in this chapter.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Control Techniques DIN1220075A and is the answer not in the manual?

Control Techniques DIN1220075A Specifications

General IconGeneral
BrandControl Techniques
ModelDIN1220075A
CategoryServo Drives
LanguageEnglish

Related product manuals