*
M’Ax User Guide 31
Issue Number: 4
6 Setting Up the Drive for
Basic Applications
The setting-up instructions are presented in the form of flow diagrams,
as follows:
Procedure for version _AN
• Power-up routine
• Select speed reference routine
• Ramps routine
•Startingroutine
Procedure for version _SL
(control via serial communications; also suitable for version _AN)
• Power-up routine
• Select speed reference routine
• Ramps routine
•Startingroutine
Setting up requires you to adjust parameters; information on these is
giveninChapter8Menu 0 Parameters on page 44 and Chapter 9
Advanced Parameters on page 51.
If any of the following apply...
• An external braking resistor is to be used
• The analog input is to be calibrated
• The programmable parameter is to be set up
... before continuing, follow the instructions in Chapter 7 Security and
Accesssing the Advanced Parameters on page 42. When setting up is
completed, follow the instructions for locking security.
To Next Page
Loading...
