*
M’Ax User Guide 43
Issue Number: 4
7.6 Locking Standard Security
When AC power is removed and subsequently re-applied, Standard
Security and User Security (when set up) are locked.
Lock Standard and User Security without removing AC power, as
follows:
1. Select parameter XX.00 (in any menu).
2. Set the value at
2000.
3. Press:
7.7 Selecting an advanced menu
1. Follow the instructions in Unlocking security earlier in this chapter.
2. Within eight seconds of unlocking security, press as many times as
required...
... in order to select the required menu (Menu 3 shown below).
Note that parameter number
3.00 is displayed; e.g. parameter XX.00
in the newly selected menu is selected.
3. Select the required parameter as described in Selecting a parameter
to access on page 23.
If required, see also Changing the value of a parameter on page 23.
and
To Next Page
Loading...
Need help?
General
