Control Techniques M'Ax 403 User Manual

*
M’Ax User Guide 39
Issue Number: 4
Set parameter
at .
10.55
1
Internal
braking resistor protection disable
1
Is an external braking resistor
used?
2
Does the Drive require de-rating?
NO
Y
ES
Initiate storing new values by
setting parameter
at ( ).
0.50
2Prog
Parameter
transfer selector
NO
S
ee in
Chapter 2 of the Installation Guide.
Planning the installation
Y
ES
8
Parameter
is set at and the
motor is being driven?
10.02
1
Drive running
indicator
When the motor speed is constant,
check that the values of parameters
and are the same.
0.04 0.05
YES
3
4
Execute storing by setting
parameter at .
10.38 100
5
To use the stored values after the
next power-up, ensure parameter
is set at ( ).
0.50 4 boot2
After changing the setting, set
parameter at .
10.38 100
6
Close the
contact .
Hardware enable
The next step will start
the motor running
7
Close the contact. RUN
O
pen the contact, then see
Appendix B .
RUN
Diagnostics
N
O
P
arameter
is set at ; motor is
stopped.
10.02
0
Drive running
indicator
9
I
f the mechanical resonances occur
when the motor is running, see
in
in Appendix D
T
esting the system Specifying shaft
stiffness and load inertia
O
ptimising the Dynamic Performance.
Basic setting-up is completed.
See later in
this chapter.
Optional setting-up
Alternatively, set
at .
11.67
1
Flash
update enable

Control Techniques M'Ax 403 Specifications

General

Brand	Control Techniques
Model	M'Ax 403
Category	Servo Drives
Language	English