Control Techniques M'Ax 406 User Manual

*
M’Ax User Guide 35
Issue Number: 4
Set parameter
at .
10.55
1
Internal
braking resistor protection disable
1
Is an external braking resistor
used?
2
Does the Drive require de-rating?
NO
Y
ES
Initiate saving the new values by
setting parameter at .
XX.00 1000
NO
S
ee in
Chapter 2 of the Installation Guide.
Planning the installation
Y
ES
9
Display shows and the motor
is being driven?
run
When the motor speed is constant,
check that the values of parameters
and are the same.
0.04 0.05
YES
3
4
After changing the setting and
while the display is in Edit mode,
press at the same time:
and
5
To use the saved values after the
next power-up, ensure parameter
is set at .
0.50 no
After changing the setting and
while the display is in Edit mode,
press at the same time:
a
nd
6
Close the
contact and ensure parameter
at .
Hardware enable
6.15 1
Drive enable
7
Display shows . StP
The next step will start
the motor running
8
Close the contact. RUN
O
pen the contact, then see
Appendix B .
RUN
Diagnostics
N
O
Display shows ; motor is
stopped
TrP
10
I
f the mechanical resonances occur
when the motor is running, see
in
in Appendix D
T
esting the system Specifying shaft
stiffness and load inertia
O
ptimising the Dynamic Performance.
Basic setting-up is completed.
See later in
this chapter.
Optional setting-up

Control Techniques M'Ax 406 Specifications

General

Brand	Control Techniques
Model	M'Ax 406
Category	Servo Drives
Language	English