Convotherm 6.06 mini - Setting Up on a Work Table

5.4 Setting up the unit on a work table
Rules for safely setting up the unit
Observe the following rules in order to ensure that the unit will have the required stability:
■
It must be possible to set up the work table at the installation location in such a way that it will not
topple over or shift. All supporting surface requirements must be met.
■
When placed on top of a work table, the unit must be secured in such a way that it will not slide out
of place.
Setting up the unit on a work table (6.06/6.10 mini)
1.
Place the unit on the work table.
2.
Use the enclosed washers (1) to level the unit.
Use a spirit level to make sure that the unit is properly
leveled.
Setting up the unit on a work table (10.10 mini)
1.
Place the unit on the work table.
2.
Use the unit's height-adjustable feet (1) to level the unit.
Use a spirit level to make sure that the unit is properly
leveled.
5 Setup
Installation Manual 36