Convotherm 6.06 mini - Performing the Electrical Installation

6.1.2 Performing the Electrical Installation
Prerequisites
Check whether the following prerequisite is met:
■
The unit's connection point has been de-energized and locked and tagged out.
Performing the Electrical Installation
1.
1
2
Connect the unit to the equipotential bonding system at
the intended connection point (1).
2.
If necessary, reset the safety thermostat for the oven cav‐
ity.
3.
Connect the appropriate power plug to the power cord
(2). For permissible power plugs, please refer to 'Electri‐
cal ratings' in 'Technical Data'
(applies exclusively to units that are not already ready to
be connected)
4.
Carry out the relevant country-specific electrical tests.
6 Installation
Installation Manual 42