Convotherm 6.06 mini - Checking the Water Quality

6.4.2 Checking the water quality
Required tools:
You will need the following tools:
■
1 sample jar for getting a sample
■
1 conductivity meter (part No. 3019007)
■
A general hardness and carbonate hardness analysis kit, including two beakers (part No. 3019010)
■
Protective gloves
Checking the water quality:
Measure the water's conductivity and total hardness. To do so, follow the instructions for the meter
and the analysis kit.
Compare the measured values with the required values in the
'Technical Data' on page 57 section.
6 Installation
Installation Manual 48