COP Security XT Series - Page 40

40
3-6-5. SETUP-ALARM/SENSOR-ALARM OUTPUT
This Sub-Menu activates or disables the alarm outputs.
1) Highlight [ALARM OUTPUT] using (▲)(▼) buttons, and press [ENTER] button to enter the Sub-Menu.
2) Using the Cursor (▲)(▼)(◀)(▶) buttons, highlight the ON / OFF selection adjacent to the Alarm
Output that is to be changed. Press the [ENTER] button to display the selection window.
3) Highlight On/Off by using (▲)(▼) buttons, and press [ENTER] button to apply the selection.
4) Press the [MENU] button to exit the Sub-Menu.
3-6-6. SETUP-SENSOR/ALARM-ALARM OUT PERIOD
This Sub-Menu sets the duration of the alarm outputs.
1) Highlight [ALARM OUT PERIOD] using (▲)(▼) buttons, and press [ENTER] button to enter.
2) The current Alarm Output duration will be displayed. If this is to be changed press [ENTER].
2) Using the Cursor (▲)(▼) buttons, highlight the period for the Alarm outputs to remain active.
3) Press the [ENTER] button to apply the selection.
4) Press the [MENU] button to exit the Sub-Menu.
[SETUP-SENSOR / ALARM]
- SENSOR TYPE
- ALARM MOTION MANAGER
- ALARM SENSOR MANAGER
- ALARM BUZZER
-<ALARM OUTPUT>
- ALARM OUT PERIOD
[SETUP-SENSOR/ALARM-ALARM SENSOR OUTPUT]
ALARM 01 <- OFF> ALARM 03 - OFF
ALARM 02 - OFF ALARM 04 - OFF
TYPE
-ON
-OFF
-OFF
[SETUP-SENSOR / ALARM]
- SENSOR TYPE
- ALARM MOTION MANAGER
- ALARM SENSOR MANAGER
- ALARM BUZZER
- ALARM OUTPUT
-<ALARM OUT PERIOD>
[SETUP-SENSOR/ALARM-ALARM OUT PERIOD]
- CONTINUOUS
OUT PERIOD
- 30 SEC
- 01 MIN
- 03 MIN
- 10 MIN
- CONTINUOUS
-03 MIN
3. SETUP