Cortalk RMU5 Generic - USB Driver Installation Steps

MOBILTEX® DATA LTD.
TITLE:
RMU5 Generic Installation and Configuration Guide
Calgary, Alberta
DOCUMENT NO.:
RMU5-MAN-001
SHEET:
26 of 69
REV:
1.10
5.1.2 USB Driver
From the RMU5 Installer screen, click the “Install RMU5 Programming Interface Drivers” button. Note that to install
drivers, you must be logged into the PC with an account that has administrative privileges. The following screen
should display while the driver is installing:
Figure 23 Driver Installation Wait Dialog
The following dialog may also appear depending on the code signing requirement setting on the PC. Click “Continue
Anyway” to complete the installation.
Figure 24RMU5 Driver Code Signing Warning Dialog
The following dialog will appear when driver install is complete. Click “OK” to continue.
Figure 25 RMU5 Driver Installation Complete Dialog
To complete installing the driver, ensure that the RMU5 is powered, then attach a USB A-B cable between the USB host
port on the PC and the USB slave port on the RMU5 (labeled “Local Config”). The following dialog may appear on the
PC: