Cortalk RMU5 Generic - RMUSetup Application Basics

MOBILTEX® DATA LTD.
TITLE:
RMU5 Generic Installation and Configuration Guide
Calgary, Alberta
DOCUMENT NO.:
RMU5-MAN-001
SHEET:
29 of 69
REV:
1.10
5.2 RMUSetup Application
Configuration of the RMU5 is performed using an application, RMU5Setup.exe, provided by Mobiltex on the same CD
that contained the USB driver file. After completing the installation process from the CD, start the application from the
Windows start menu using the “RMU5-Generic Setup” shortcut located in the “RMU5 Configuration Application”
subfolder.
The following dialog will appear:
Figure 30 Configuration Application Main Screen At Startup
The first step in using RMUSetup is to connect to the RMU5. Ensure that the USB driver has been installed as outlined
in section 5.1.2, and that the USB cable is attached between the PC and the RMU5. Select the ‘USB’ radio button in the
dialog, and then click on “Connect”. The following dialog will appear:
Figure 31 Connect Password Dialog
Enter the RMUSetup default username of “admin” and the default password of “admin” and click on “OK”.