61
PROBLEM POSSIBLE CAUSE SOLUTION
Oven door is
locked and
will not
release, even
after cooling.
Turn the oven off at the circuit breaker
and wait a few seconds. Turn breaker
back on. The oven should reset itself
and will be operable.
Oven is not
heating
No power to the
oven.
Check the circuit breaker or fuse box to
your house. Make sure there is proper
electrical power to the oven.
Oven mode or
temperature not
started or selected
Make sure the oven mode and
temperature have been selected, and
Start button has been pressed.
Oven is not
cooking
evenly
Not using the
correct bake ware
or oven rack
position.
Refer to cook charts for recommended
rack position. Always reduce recipe
temperature by 25 °F (15 °C) when
baking with Convention Bake mode.
Oven display
stays Off
Power
interruption.
Turn off power at the main power
supply (fuse or breaker box). Turn
breaker back on. If condition persists,
call for service.
Cooling fan
continues to
run after
oven is
turned off
The electronic
components have
not yet cooled
sufficiently.
The fan will turn off automatically
when the electronic components have
cooled sufficiently.
Oven light is
not working
properly
Light bulb is loose
or burned-out.
Reinsert or replace the light bulb.
Touching the bulb with fingers may
cause the bulb to burn out.
Oven light
stays on
Oven door is not
completely closed.
Check for obstruction in oven door.
Check to see if hinge is bent or door
switch is broken.
Cannot
remove light
cover
Soil build-up
around the light
cover.
Wipe light cover area with a clean, dry
towel prior to attempting to remove
the light cover.
To Next Page
Loading...
Need help?
General
